Advertisement
2
U
STRM 2008.2
PGRADING TO
Upgrading to STRM
2008.2
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
version since this results in lost changes for STRM 2008.2. You must re-apply
your custom crontab configuration after the upgrade process.
•
Make sure that you have Java Runtime Environment installed on your system.
You can download Java version 1.5.0_12 at the following web site:
http://java.com/.
To upgrade to STRM 2008.2 from STRM 2008.1:
Note: Before you begin the upgrade process, make sure you review the
You Begin
section. This section outlines requirements that must be satisfied before
you begin the upgrade process.
Go to the Juniper Networks web site to access the STRM 2008.2 software:
http://www.juniper.net/support
Click the Management Software link and log in. Go to the Security Threat
Response Manager Link to download the software.
Copy the file to the /tmp folder on your system.
Note: Make sure you copy the appropriate upgrade file for your operating system
to the /tmp folder.
Log in as root.
Create a folder named cdrom
mkdir /media/cdrom
Run the following command:
mount –t iso9660 –o loop /tmp/STRM2008.2.iso /media/cdrom
Enter the following command:
./media/cdrom/setup
Read the messages and answer the prompts.
The following prompt appears:
About to upgrade your STRM from 2008.1 to 2008.2. Continue
(Y/[N])?
To continue, enter
.
Y
If STRM was previously upgraded, a prompt appears informing you that a previous
backup was found.
Enter
to proceed with the upgrade.
y
If the current operating system kernel is older than the version in the upgrade, a
prompt appears informing you this kernel will be replaced.
Enter
to proceed with the upgrade.
y
Wait for upgrade process to complete. This process may require up to several
minutes, depending on your system. When the process is complete, a message
appears:
Before
Advertisement
