Installing Strm-Lm; Setting Up Appliances - Juniper SECURITY THREAT RESPONSE MANAGER - LOG MANAGEMENT INSTALLATION REV 1 Installation Manual

2
Setting Up
Appliances
Step 1
Step 2
Step 3
Step 4
I
NSTALLING
This chapter provides information on installing your STRM-LM system using one of
the following options:
•

Setting Up Appliances

Installing Japanese Support
•
Accessing STRM-LM
•
A STRM-LM appliance includes STRM-LM software and a CentOS-4 operating
system. This section provides information on setting up your appliance. For more
information on appliances see the Hardware Installation Guide.
To set-up your appliance:
Install all necessary hardware.
For information on rack mounting your STRM-LM appliance, see the Hardware
Installation Guide.
Choose one of the following options:
Connect a laptop to the serial port on the rear of the appliance.
a
Note: When using a laptop to connect to the system you must use a terminal
program, such as HyperTerminal, to connect to the system. Be sure to set
Connect Using to the appropriate COM port of the serial connector and Bits per
second to 9600. You must also set Stop Bits (1), Data bits (8), and Parity
(None).
Connect a keyboard and monitor to their respective ports.
b
For more information on appliance ports, see the Hardware Installation Guide.
Power on the system and log in to STRM-LM:
Username: root
Password: password
Note: The username and password are case sensitive.
Press Enter.
The End User License Agreement (EULA) appears.
STRM-LM Installation Guide
STRM-LM