Replacing Cooktop Light; Replacing Microwave Oven Light - Whirlpool MH1160XSB Use And Care Manual

To Remove and Replace Charcoal Filter:
1. Remove the 2 vent grille mounting screws located directly
behind the top louver.
A B
C
A. Vent grille
B. Top louver
C. Mounting screws
2. Tip the vent grille forward and down, then lift to remove.
The microwave oven light is a candelabra base bulb. It will
automatically come on when the door is opened and when the
microwave oven is operating. See "Assistance or Service"
section to reorder.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Remove the 2 vent grille mounting screws located directly
behind the top louver.
A B
C
3. Slide filter back slightly, lift front end, and pull out filter.
A. Vent grille
B. Top louver
C. Mounting screws
3. Tip the vent grille forward and down, then lift out to remove.
4. Install new charcoal filter.
5. Replace vent grille and mounting screws.
The cooktop light is a candelabra base bulb. See "Assistance or
Service" section to reorder.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Remove the bulb cover mounting screw.
A ¸-
4. Lift up the bulb cover.
A. Bulb cover
5. Replace light. Close bulb cover.
6. Reattach vent grille. Replace the mounting screws.
7. Plug in microwave oven or reconnect power.
A. Mounting screw
3. Replace light. Close bulb cover. Replace mounting screw.
4. Plug in microwave oven or reconnect power.
13