D-Link DI-707 User Manual page 14

by crossover Ethernet cable. If the hub you connected has an UPLINK port, you can also
connect DI-707 with straight through Ethernet cable to that UPLINK port.
4. Power on: Connect the power cord to a power outlet and turn the power switch on. The
DI-707 will automatically enter the self-test phase. When in the self-test phase, the
indicators M1 and M2 will be lighted ON for about 5 seconds, and then M1 and M2 will
flash three times to indicate that the self-test operation has finished. Finally, the M 1 will
flash continuously once per second to indicate that the DI-707 is in normal operation.
6
Rev: 10102000