Advertisement
Quick Links
FL-2025,FL-
6020
AND MMB-31 M OBILE MOUNTING
POR THE FT-290UPT-690R11
The FL-2025
(25-watt),
Linear Amplifiers are designed to provide increased power for base
and mobile operation with the FT-290R11, FT-690R11 and FT-790Rll
All
Mode
VHF
and
Mobile
Mounting
in which
the Amplifier
Transceiver may be easily slid in and out of the bracket for quick
conversion
to portable
ly, the Amplifier may be left attached to the Transceiver for quick
conversion
to base operation.
AMPLIFIER
SPECIFICATIONS:
Amateur
Radio
Band:
Operating Current (max):
Power output (±20%):
Types of emission:
Operating
voltage:
Spurious emissions:
Output impedance:
Size
(WHD):
Weight:
&FL-7025 L INEAR AMPLIFIERS
FL-6020 (10-watt) and FL-7025 (25-watt)
UHF
Transceivers,
Bracket provides a convenient mobile installation
may be installed
operation
without
FL-2025
2m
5.5A
25W
SSB, CW, FM
12.4 to 15.8 VDC,
-60dB
50 ohms,
unbalanced
148
x
57
x 65mm
approx.
I
kg
BRACKET
& FT-790R11
The
MMB-31
permanently, while the
the amplifier.
Alternative-
FL-6020
FL-7025
6m
70cm
3A
tow
25W
negative
ground
YAESU MUSEN
C.P.O.
BOX
1500
TOKYO,
JAPAN
CO., LTD
Advertisement
Related Manuals for Yaesu FL-2025
Summary of Contents for Yaesu FL-2025
- Page 1 &FL-7025 L INEAR AMPLIFIERS AND MMB-31 M OBILE MOUNTING BRACKET POR THE FT-290UPT-690R11 & FT-790R11 The FL-2025 (25-watt), FL-6020 (10-watt) and FL-7025 (25-watt) Linear Amplifiers are designed to provide increased power for base and mobile operation with the FT-290R11, FT-690R11 and FT-790Rll...
- Page 2 AMPLIFIER CONNECTORS 13.8 VDC Cable Pigtails This cable accepts 12 to to power the transceiver Amplifier. RED lead must be connected to positive voltage, the BLACK lead •to negative (ground). Coaxial Jack This type-M connector (type-N roq FL-7025) must be connected a proper antenna *lone having 50 ohms impedance across the operating band)'.
- Page 3 RF Jack This phono plug accepts RF excitation from, and provides receiver input to the transceiver. When this plug is connected to its mating jack transceiver jack on the front panel transceiver disconnected, and the jack on the Amplifier becomes active instead.
- Page 4 MOBILE INSTALLATION The FL-2025, FL-6020 and FL-7025 are each supplied with a fused DC Cable for connection to the vehicle battery in mobile installa- tions. If you decide to install the Amplifier in the MMB-31 bracket, use the four bolts...
- Page 5 Use the shortest practical length of 50-ohm coax feedline, with a type-M plug (P L-259) the FL-2025/FL-6020 (or type-N for the FL-7025) at the transceiver end. Make sure the antenna is specifically designed the amateur band in use. Note:...
- Page 6 Amplifier. Use the shortest practical length of 50-ohm coax the feedline, with a type-M plug (PL-259) for the FL-2025/F L-6020 a type-N plug for the FL-7025) at the transceiver end. The antenna should specifically designed 2-meter...
- Page 7 IN/WT 06201 06207.0B 1-6207 RL620f t•S7727 M1402 COLPLER 06202 06206 CtRRENT 2s0882Q ISS97 TRANSMI RECEIVE FL-2025 BLOCt<...
- Page 8 0.001 IN/OUT M57727 0.751 2SA733AP 2SD882Q -t 0k IOE' 2SC945AP +13.ev 25W L IrE-AR AT I-NIT F2847000 (No.62xx RESISTOR VALUES ARE IN o. t/4w: CAPACITOR VALLES ARE IN PF. sowv : ltOJCTOR VALUES ARE IN I-EFRIES: UtCESS OTHERWISE NOTED.
- Page 9 FL-6 0.01 MS773S 1-07 L 03 1 S97 2SA733AP 2SDBB2Q ' sss IOE' 2SC945AP +13.ev UNIT F2847000 (No.60xx) LINEAR RESISTOR 1 zaw: CAPACITOR VALUES sowv: IFOUCTOR VALVES I.R•ILESS OTHERWISE t•OTED.
- Page 10 F2904000 (No.6Sxx 0.001 IN/OUT MS 7745 LosMP&2 2SC945AP 0.33p At-c 2SD882P • 13.ev HZ5C2 OOS :HZ4C3 2SA733AP 2SC945AP RESIST'* VALLES n.t/6w: CAPACITOR VALUES ARE IN pF.SO„v: VALVES }-ESRIEs: UNLESS OTHERWISE NOTED.
- Page 11 0.001 IN/OUT MS7727 1-04 2SA733AP R 090 2 ; 2SD8B2Q ISS53 1 OEI 2SC9 +13.ev I-IBEAR UNIT F2847000 (No.62xx) RESISTOR VALUES 1/4W: CAPACITOR VALUES ARE IN PF. sowv : lhOUCTOR VALLES k-EtRIEs: UN-ESS OTHERWISE NOTED.
Need help?
Do you have a question about the FL-2025 and is the answer not in the manual?
Questions and answers