Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Getting Started Manual page 3

All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Additional Commands and References
To verify the contents of the flash, enter the following command at the router prompt:
show flash:
training#show flash:
24576K bytes of processor board System flash (Intel Strataflash)
Directory of flash:/
2 –rwx 17198508 --- -- ---- --:--:-- ----- c870-
advipservicesk9-mz.12.4-11.T1
3 drwx 0 Aug 11 2006 23:16:18 -08:00 ipsstore
23482368 bytes total (6279168 bytes free)
To rename the directory name, use the Rename Directory Command example or the combination
of the Remove Directory Command and Create Directory Command at the router prompt.
Rename the directory (Rename Directory Command):
rename <current name> <new name>
training#rename ipsstore ips
Destination filename [ips]?
OR
First remove the directory (Remove Directory Command):
rmdir <current directory name>
Create the directory again (Create Directory Command):
mkdir <new directory name>
training#rmdir ips
Remove directory filename [ips]?
Delete flash:ips? [confirm]
Removed dir flash:ips
training#mkdir ipsstore
Create directory filename [ipsstore]?
Created dir flash:ipsstore
White Paper
Page 3 of 12