Default Settings - NETGEAR GS105E-100NAS - Prosafe Plus 5PORT User Manual

ProSafe Unmanaged Plus Switch Configuration Utility User Guide

Default Settings

All ProSafe® Plus Switch features have default settings. You do not need to configure any
settings in order to use the ProSafe® Plus switches. The following table lists the default
values for switch settings. Shaded features are not configurable on all switches.
Tab Menu
System
Maintenance
Monitoring
Feature
Status
Switch Information
Change Password
Firmware Upgrade
MultiCast
IGMP Snooping Status
VLAN IDEnabled for IGMP Snooping
Validate IGMPv3 IP header
Block Unknown Multicast Address
Switch Selection No switch selected
Names All names blank
Passwords "password" for all switches
DHCP Mode Enabled
IP Address 192.168.0.239
Subnet Mask 255.255.255.0
Gateway Address 192.168.0.254
All fields blank
Device Reboot Unchecked
Factory Default Unchecked
Filename blank
Port Statistics 0
Mirroring Disabled
Cable Tester OK or No Cable for each port
Enabled
1 (not configurable until VLAN is enabled)
Disabled
Enabled
Chapter 1: Getting Started
Default Value
| 9