Taylor 1730/5257016 Instruction Manual

TAYLOR
Wireless Indoor/0utdoor
Model 1730/5257016
Simple, reliable, accurate...the wireless thermometer allows you to monitor indoor or outdoor locations from one
room. The base unit reads indoor conditions, while the remote sensor wirelessly reports outdoor weather conditions
back to the base unit for an all-in-one weather display.
NOTE:Some units have a static cling label over the digital display. Please remove before use.
BATTERY INSTALLATION
The base unit operates on 2 AAAbatteries and the remote sensor operates on 2 AAAbatteries (batteries not
included). Do not mix old and new batteries. Donot mix alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
IMPORTANT:Install batteries in the base unit first, then the remote sensor, otherwise the units' transmissions may
not properly connect. Place the base unit as close as possible to the remote sensor when installing batteries.
TIP: When the temperature falls below freezing point, alkaline batteries used in outdoor units may freeze, lowering
their voltage supply and effective range. Use of Lithium batteries is recommended in extremely cold or hot locations.
Base Unit
The battery compartment is located on the back of the unit. Removethe battery compartment door. Install (2) AAA
size batteries into the battery compartment according to the polarity markings. Replace the battery compartment
door.
Remote Sensor
The battery compartment is located on the back of the unit. Slide off the battery compartment cover. nstall (2)AAA
size batteries into the battery compartment according to the polarity markings. Replace the battery compartment
door.
After Batteries are Installed:
When the units are powered up, the LCDscreen on the base unit will light up for 3 seconds, then the unit will display
initial indoor temperature readings. The outdoor temperature display will show dashes
Allow at least 3 minutes for the base unit to connect with the remote sensor and analyze current outdoor
temperature conditions. A transmission signal icon
When the icon is steady, the base unit has connected with the remote and is reporting the current outdoor
temperature.
If after 3 minutes the transmission signal icon
button on the front of the base unit for 3 seconds to send another signal. For best setup connection, keep the base
unit and remote close to each other while trying to connect. Keep away from other electronic equipment that may
interfere with the connections, such as mobile phones, appliances, computers, refrigerators, TVs, etc.
Indoor temperature readings update on the base unit approximately every 30 seconds. The remote sensor transmits
outdoor temperature readings to the base unit approximately every 57 seconds. A red light flashes on the sensor
when it sends a transmission signal.
Note: While the base unit is in "analyzing" mode, other functions (such as setting the clock) may not be operational
or using the functions will interrupt the transmission reception. Oncethe "analyzing" mode is complete, the other
functions will become operational.
Thermometer with Remote Sensor
') flashes by the "OUT"temperature digits during this time.
stops flashing and dashes remain, press and hold the
INSTRUCTION MANUAL
O