Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910252 CHAP 6 Manual page 8

Control Sources
Main Control Source List
38
39
40
41
42
43
44
45
46
6-8
Global ASR (GASR2)
When the Globals parameter on the COMMON page is turned on, ASR2 becomes
global, and is labeled GASR2. The functions of ASRs are explained in Chapter 6 in
the Performance Guide , in the section "The ASR Page." This control source does not
appear in the Control Source list for parameters whose functions are local.
Global FUN2 (GFUN2)
When the Globals parameter on the COMMON page is turned on, FUN2 becomes
global, and is labeled GFUN2. The functions of FUNs are explained in Chapter 16
in the Performance Guide . This control source does not appear in the Control Source
list for parameters whose functions are local.
Global LFO (GLFO2)
When the Globals parameter on the COMMON page is turned on, LFO2 becomes
global, and is labeled GLFO2. The functions of LFOs are explained in Chapter 6 in
the Performance Guide , in the section "THE LFO PAGE." This control source does
not appear in the Control Source list for parameters whose functions are local.
Global LFO Phase (GLFO2ph)
When the Globals parameter on the COMMON page is turned on, LFO2 becomes
global, and is labeled GLFO2. The functions of LFOs are explained in Chapter 6 in
the Performance Guide , in the section "THE LFO PAGE." This control source does
not appear in the Control Source list for parameters whose functions are local.
Global FUN 4 (GFUN4)
When the Globals parameter on the COMMON page is turned on, FUN 4 becomes
global, and is labeled GFUN4. This control source does not appear in the Control
Source list for parameters whose functions are local.
Volume Control (VolCtl)
This control source will always respond to MIDI controller 07 messages. Assign
this value to a parameter when you want MIDI volume messages to affect the pa-
rameter.
Pan Control (PanCtl)
This control source always responds to MIDI controller 10 messages. Assign this
value to a parameter when you want MIDI pan messages to affect the parameter.
Balance Control (BalCtl)
This control source will always respond to MIDI controller 08 messages. Assign
this value to a parameter when you want MIDI balance messages to affect the pa-
rameter.
Channel Count (ChanCnt)
This control source keeps track of the total number of active voice channels (how
many notes are playing), and converts the number into a control signal between 0
and +1. The control signal's value is 1 when all 48 voice channels are active, and 0
when no voice channels are active.
You can use this control source in several ways. One example is to limit the volume
of each note so that you have a more nearly constant volume regardless of how