Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910251 CHAP 6 Manual page 20

Program Mode and the Program Editor
Program Editor—F4 AMP Page
amplitude, so with a large positive value, the amplitude will be low when you play softly.
Small values decrease the range between min and max, so with a small positive value, you'll
get nearly full amplitude even with light attack velocities.
Pad
Select one of four attenuation levels for cutting the amplitude of the current layer before the final
amp stage (Pre-amp pad). Use the pad if the layer's sound distorts when played. Note:
clipping can occur in earlier algorithm blocks as well. If this is the case, you'll probably want to
try to remove the clipping in the earlier block, if possible.
Sources 1 and 2, Depth Controls
These are common DSP control parameters, which in this case let you assign control sources to
affect the amplitude of the current layer. The functions of common DSP control parameters are
explained in their own section earlier in this chapter.
6-20