Advertisement
Quick Links
AEG
Bitte geben Sie unserem Kundendienst folgende Angaben bei einer
Störung an:
If your appliance has a fault, please contact our service engineerand
state the following numbers:
E-Nr.
942
F-Nr.
AEG Hausgeräte GmbH
Postfach
1036
D-90327 Nürnberg
AUS
ERFAHRUNG
O Copyright by AEG
GUT
- 0296/02
3)-2q
(4OOOH
Dir.
89/336/CEE
4324338
-
120
D
Flach-Dunstabzugshaube
Flatscreen cookerhood with chimney
Montage-und Gebrauchsanweisung
Installationand Operating Instructions
AUS
ERFAKRUNG
GUT
Advertisement
Related Manuals for AEG 120 D
Summary of Contents for AEG 120 D
- Page 1 If your appliance has a fault, please contact our service engineerand state the following numbers: Flach-Dunstabzugshaube Flatscreen cookerhood with chimney E-Nr. F-Nr. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg Dir. 89/336/CEE Montage-und Gebrauchsanweisung ERFAHRUNG O Copyright by AEG ERFAKRUNG Installationand Operating Instructions 4324338 - 0296/02 3)-2q (4OOOH...
- Page 2 Contents Pages Generality Evacuation mode Recirculation mode Electrical connection Safety warning for the Electrician Connection Technical Data Installation Instructions Safety warning for the Installer 26/27 Installation of the upper rail Fixing the cookerhood Installation of the wall fixing brackets 28/29 Fixing the cookerhood body 29/30...
- Page 3 Put the lever in the "Recirculation" position - Fig. 3 (Accesory). The original AEG charcoal filter (see Accessories) has to be Theappliance is forseen of an upperducting outletdiameter fitted recirculation mode.
- Page 4 Electrical connection Dimensions Befor connecting the appliance to the mains supply, ensure Technical Data Safety warning Height Length Depth (in cm) that the mains voltage corresponds withthe voltage on the rating plate inside the cokerhood. Should the appliance be forseen of Cookerhood body 59,8...
- Page 5 Safety Duct for evacuation mode should be of 120mm diameter. A loss of air capacity as well as higher noise level will be Safety caused when not following the above indicated instructions. warnings warnings When installed, the hood must be positioned at least Kitchen Kitchen...
- Page 6 Installation Place one of the two wall brackets item 2 (Fig. 6) 1 to Fixing wall wall fixing 2mm from the ceiling or from a horizontal line drawn brackets between the top of the adjoining wall cabinets, ensuring brackets that the bracket is level and mark the centre for the key hole bracket fixing screws.
- Page 7 Fixing Hook the cookerhood body C onto the wallfixing brackets i Fitting . an—a ensuring that the security fixing screws align with the holes in cookerhood telescopic the centre of the back panel of the cookerhood as illustrated body chimney in Fig.
- Page 8 Operating This cookerhood is equipped with one motor and can be Before carrying out any kind of cleaning or maintenance, Safety operated on differént working speeds. It is recommended cookerhood disconnect the hood from the mains supply. warnings switch on the cookerhood a few minutes before starting cooking user and to leave the cookerhood working till 15 minutes after starting Grease filter and charcoal filter should be cleaned or replaced...
- Page 9 Replacement: Open the metal grease filter (Fig. 11) and unscrew the charcoal Grease filters can be requested by AEG After Sales Service filter knob from its seat (Fig. 13). (see Accessories). If the cookerhood is been supplied in the recirculation mode...
- Page 10 Accessories Disconnect the cookerhood from the mains supply. Kitchenkabi Worktop 118 611 Open the metal grille Ductingtube illumination Replace the lamps with a max. 40W bulb. (Ø 120 mm) Befor calling the After Sales Service, if on the lamps does not work, ensure that it is correctly screwed in.
Need help?
Do you have a question about the 120 D and is the answer not in the manual?
Questions and answers