VOLTCRAFT IPC-1 Operating Instructions Manual page 23

Table 7. Various displays in Test Mode
Stage in Test
mode
During charging
During
discharging
During 2nd
charging
Full stage
Note:
*The timer will be resumed and counted from 00:00 again after the time elapsed is longer
than 20 hours. (For example, 1:45 will be shown after the battery has been refreshed for 21
hr and 45 min.)
In case the power source is shortly interrupted or terminated when the charger is being
operated, the operational mode will automatically be set to "Charge mode at 200 mA" to
charge up the battery once the power source is back to normal, regardless the operating
mode (Charge, Discharge, Refresh or Test) which has been selected by user before.
THE SIZE C AND SIZE D BATTERY ADAPTERS (FREE ACCESSORY)
The battery adapters are used for connecting the AA battery to the electric devices requiring
Size C or D batteries. To apply the adapter:
1. Install the AA battery to Size C or Size D adapter as below.
The AA battery used
with the Size C adapter
2. Ensure the polarity is correct and the assembling condition is good.
Note:
User shall stop using the adaptor when there are any cracks or damages observed in the
adaptor, and in case undesired smell comes out while applying the adapter in certain kinds
of electric device.
Various displays (toggled by pressing DISPLAY key)
Voltage (V)
Charging current
Instantaneous
Charging current
Battery voltage
Trickle charging
Current (mA) *Time (hh:mm)
Discharging Discharging time
current
2nd charging time
Discharging time
current
Charging time
elapsed
elapsed
Capacity of the
elapsed determined in
Capacity of the
elapsed determined in
The AA battery used with the
Size D adapter (it is required to
place the battery into the "C"
adapter first and then the "D"
adapter)
Capacity
(mAh/ Ah)
"--- mAh"
"--- mAh"
battery
discharging
battery
discharging
23