Download Print this page

Technical Support; Regulatory Compliance - NETGEAR AXM761 - ProSafe 10 Gigabit Installation Manual

Prosafe 10 gigabit ethernet sfp+ module

Advertisement

AXM761_IG_10July09.fm Page 2 Friday, July 10, 2009 2:36 PM

Technical Support

Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the label of your product and use it
to register your product at http://www.NETGEAR.com/register. Registration is required
before you can use our telephone support service. Registration via our web site is strongly
recommended.
Go to http://kbserver.netgear.com for product updates and Web support. For Warranty and
Regional Customer Support information, see the Warranty Card that came with your
product.

Regulatory Compliance

Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability,
NETGEAR reserves the right to change the product described in this document without
notice. NETGEAR does not assume any liability that may accrue due to the use or
application of the product(s) or circuit layout(s) described herein.
Certificate of Manufacture/Importer
It is hereby certified the NETGEAR model AXM761 has been suppressed in accordance
with the condition set out in MBPT-Amtsb|Vfg 243/1991 and vfg 46/1992. The operation of
some equipment (for example, test transmitters) in accordance with regulation may,
however, be subject to certain restrictions. Please refer to the note in the operating
instructions. Federal Office for Telecommunications Approvals has been notified of the
placing of this equipment on the market and has been granted the right to test the series for
compliance with regulation.
Note: This device has been tested and found to comply with limits for a Class B digital
device, pursuant to part 15 of FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a commercial installation.
Laser Safety Warning
This is a Class 1 laser product.
Warning: Because invisible laser radiation may be emitted from aperture of the port when
no fiber cable is connected, avoid exposure to laser radiation and do not stare into
the open aperture.
This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste
Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union,
this product should be treated and recycled in accordance with the laws of your jurisdiction implementing
the WEEE Directive.
© 2009 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarks of
NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or
registered trademarks of their respective holders. Information is subject to change without notice.
July 2009

Advertisement

loading