Toshiba Gigabeat S MES60V Service Manual page 19

[Transfer of FW for factory setting]
9) Transfer the FW for factory setting in the same manner as instep 4). Terminate Ottoman.exe once. Start
up newly the [Transfer Program (Ottoman.exe) on the PC and select the scenario file (*.ini) in which
files to be transferred are described. Ottoman.exe and the scenario file are provided on the CD-ROM
(Material No.: 360058245). Names for the destination-wise stored folder and file are different
depending on the destination. The relationship between destination and folder is shown on the table
below.
Table Destination and Folder
Destination Folder name
Japan OTTOMAN_DEL_JP
U.S.A. OTTOMAN_DEL_US
The menu display is also the same as in step 4). Check two points of (A) and (B) on the menu in step 4).
These are different depending on the destination ((A) is same.) The display for every destination is as
shown below.
Table Differences of display by destination (Differences are underlined.)
Destination (A)
Japan version 0.9.9.10
U.S.A. version 0.9.9.10
10) Wait for a while. Then, "OK" appears on the PC.
11) Remove the USB cable. At this moment, be careful not to touch the POWER button. By removing the
USB cable, "OK" on the PC disappears. The unit is automatically started up.
12) The unit is automatically started up.
[Transfer of supplied data for factory setting]
13) Transfer the supplied data for factory setting in the same manner as in step 4). Terminate Ottoman.exe
once. Start up newly the [Transfer Program (Ottoman.exe)] on the PC and select the scenario file (*.ini)
in which files to be transferred are described. Ottoman.exe and the scenario file are provided on the
CD-ROM (Material No.: 360058245). Names for the destination-wise stored folder and file are
different depending on the destination. The relationship between destination and folder is shown on the
table below.
Scenario file name
OTTOMAN_DEL_JP.ini
OTTOMAN_DEL_US.ini
(B)
FILE DEL & TRANS PROG(JP) Ver.6423A
FILE DEL & TRANS PROG(US) Ver.6423A
15