When Replacing The Main Board; Updating The Firmware - Toshiba Gigabeat S MES60V Service Manual

Table Differences of display by destination (Differences are underlined.)
Destination
Japan
U.S.A.
13) Wait for a while. Then, "OK" appears on the PC.
14) Remove the USB cable. At this moment, be careful not to touch the POWER button.
By removing the USB cable, "OK" on the PC disappears.
15) Hold down the Power key to suspend (Power OFF).
16) Plug out the AC adaptor.
3.4.

When replacing the main board

3.4.1. Updating the firmware.

After replacing the main board, update the firmware in the procedure below.
As explained in "1.1.3 Location to store the firmware", the firmware is stored in both the flash ROM on the
main board and on the HDD. Unless the versions of firmware at two locations are matched, the malfunction
will occur. Therefore, whenever the main board is replaced, update the firmware in the procedure below to
match the versions at two locations.
For the procedure when replacing the HDD, see "3.3 When replacing the HDD".
[HDD formatting]
1) Set the BATTERY switch to "OFF".
2) Connect the AC adaptor and start up the unit.
3) Format automatically the HDD and display the menu below on the LCD. Wait until the menu appears.
Fig. Menu of waiting for the PC connection
(A)
version 0.9.9.10 TRANS SAMPLE COMTENTS(JP) Ver.6423A
version 0.9.9.10 TRANS SAMPLE COMTENTS (US) Ver.6423A
(B)
12