Dgs-1210-10P; Front Panel; Rear Panel - D-Link DGS-1210-10P User Manual

1 Product Introduction
the switches with other third-party devices for management in an SNMP-enabled environment. D-Link Web
Smart Switches also come with the D-View plug-in module that works with D-View 6 SNMP Management
Software, and provides easy-to-use graphic interface and facilitates the operation efficiency.

DGS-1210-10P

8-Port 10/100/1000Mbps plus 2 1000Base-T/SFP ports Web Smart PoE Switch

Front Panel

Power LED : The Power LED lights up when the Switch is connected to a power source.
Pwr Max: The Pwr Max LED lights up when the Switch reaches the maximum power budget defined by the
administrator via PoE System Settings page of Web GUI or the default power budget of 78 Watts.
Reset: By pressing the Reset button, the Switch will change back to the default configuration and all
changes will be lost.
Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes.
Port Link/Act/Speed LED (1-8, 9T, 10T, 9F, 10F): When mode LED lights up in Link/Act mode, the port
LEDs indicate a network link through the corresponding port. Blinking indicates the Switch is either sending
or receiving data to the port. When the port LED glows in amber, it indicates the port is running on 10M or
100M. When the port LED glows in green, it is running on 1000Mbps.
Port PoE LED (1-8): When mode LED lights up in PoE mode, the port LEDs indicate powering status over
the corresponding port.

Rear Panel

Power: The power port is where to connect the AC power cord.
Figure 1 – DGS-1210-10P Front Panel
NOTE: On DGS-1210-10P, the SFP ports are
shared with normal RJ-45 ports 9 to 10. When
optical transceiver is inserted to SFP port and
link up, the RJ-45 port cannot be used.
Figure 2 – DGS-1210-10P Rear Panel
3 3
D-Link Web Smart Switch User Manual
SFP ports for optical transceivers