Upgrading The Managed Devices - Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual

4 Log in as
, then start the upgrade program from the mount point by running the following
root
command:
./zlm-upgrade
5 When prompted to upgrade ZENworks Linux Management, enter
6 Review the Software License Agreement, pressing Page Down to scroll down the page, then
enter to accept the agreement.
Y
The install program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, runs upgrade scripts, and then restarts the ZENworks services.
7 Enter when you are asked if you are upgrading a ZENworks Primary Server.
N
8 Enter when you are asked if you have upgraded the ZENworks Primary Server.
Y
The upgrade program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, and runs upgrade scripts.
After the upgrade is complete, the ZENworks services are restarted. This might take a few
minutes.
9 (Conditional) Repeat
want to upgrade.
10 Continue with "Upgrading Managed Devices Manually" on page
or
Continue with "Upgrading Managed Devices by Using Upgrade Bundles" on page

13.1.2 Upgrading the Managed Devices

Upgrading the managed devices to ZENworks 7.3 Linux Management with IR2 installs the new
ZENworks Agent.
You can upgrade the managed devices from ZENworks 7.3 Linux Management to ZENworks 7.3
Linux Management with IR2 in one of the following ways:
"Upgrading Managed Devices Manually" on page 113
"Upgrading Managed Devices by Using Upgrade Bundles" on page 114
Upgrading Managed Devices Manually
1 Make sure the managed device meets the requirements. See
Requirements," on page
2 At the Linux managed device, mount the Novell ZENworks 7.3 Linux Management with
Interim Release 2 Agent media by using the
For example,
mount /dev/cdrom /zlm73
If you are using an ISO image rather than a physical media, copy the ISO to a temporary folder
on the Linux managed device, then mount the image using the following command:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location you want to mount the image. The path specified by mountpoint
must already exist.
For example:
Step 1 through Step 8 for each ZENworks Secondary Server that you
25.
mount device mountpoint
.
Upgrading to ZENworks 7.3 Linux Management with IR2 113
to continue.
Y
113.
114.
Section 2.3, "Managed Device
command.