Reinstall The Destination Server - Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.2 - ADMINISTRATION GUIDE 09-2007 Administration Manual

6 Type the context where the source server existed prior to migration, then press F10.
7 Save the NDS (Directory) information.
8 Wait while the server synchronizes with the eDirectory tree, which might take a while.
9 Return to the INSTALL or NWCONFIG utility and select Directory Options > Directory Back
10 Press Enter.
11 Enter the full Admin username as the placeholder object distinguished name, then specify Root
12 Exit the NWCONFIG or INSTALL utility.
13 At the server console of the source server, enter load dsrepair.
14 Select Unattended Full Repair > Advanced Options > Check Volume Objects and Trustees.
15 Enter the Admin username and password.
16 Exit DSREPAIR.
17 At the workstation where you performed the migration, open your project. (Make sure you
18 From the Migration Wizard Project menu, select Restore Trustees to restore the trustee
19 (Conditional) If the source server held the master replica of any partitions and you want to
Continue with the next section,

12.5.5 Reinstall the Destination Server

To perform the migration again, you must reinstall the operating system on the destination server.
TIP: If you had your server imaged, you can just restore the image rather than reinstall the server.
1 Bring down the destination server.
2 Install NetWare and follow the on-screen instructions during the installation.
After NetWare is installed on the destination server, you are ready to perform the eDirectory
migration again. Go to
page
118 Novell Server Consolidation and Migration Toolkit Administration Guide
Up and Restore > Restore Reference from another Object to This Server.
This restores all references that you assigned to the Server object when you removed
eDirectory from the destination server.
as the distinguished name to change from.
have removed eDirectory from the destination server, as instructed in
eDirectory from the Destination Server" on page
temporary tree with its temporary server name.)
assignments.
restore these partitions prior to doing the eDirectory migration again, use DSREPAIR to re-
create them.
The source server is now restored to its original configuration.
Section 11.7, "Migration Step 3: Begin NDS/eDirectory Migration," on
104.
116, and returned the destination server to its
Reinstall the Destination
"Remove NDS/
Server.