Novell OPEN ENTERPRISE SERVER CLUSTER SERVICES 1.8.2 - ADMINISTRATION Manual page 53

Cluster Console Command
SET {Parameter} {Value}
STATS {Display, Clear}
Description
Sets cluster parameters individually for the cluster.
See Section 3.8, "Configuration Settings," on page 44
for more information on cluster parameters.
Specify one of the following parameters and a value
for that parameter:
IPADDRESS Sets the cluster IP address to the
specified value. If you change the cluster IP
address, you must restart cluster software on all
cluster nodes.
PORT Sets, or lets you change the cluster port
number.
QUORUMWAIT This is the amount of time in seconds
that the cluster waits before resources start to load.
QUORUM This is the number of nodes that must be
running in the cluster before resources will start to
load.
HEARTBEAT This is the amount of time in seconds
between transmits for all nodes in the cluster
except the master.
TOLERANCE This is the amount of time in seconds
that the master node gives all other nodes in the
cluster to signal that they are alive.
MASTERWATCHDOC This is the amount of time in
seconds between transmits for the master node in
the cluster.
SLAVEWATCHDOC This is the amount of time in
seconds that the slave nodes give the master node
in the cluster to signal that it is alive.
MAXRETRANSMITS This is the maximum number of
times transmits will be attempted between the
master node and slave nodes.
ENABLEEMAIL Enables and disables e-mail
notification. You can set the value to OFF to
disable e-mail notification, or either CRITICAL or
VERBOSE to enable e-mail notification.
EMAILADDRESSES Lets you specify the e-mail
addresses used for e-mail notification. The
addresses should be separated by spaces. Using
this parameter without specifying any addresses
will clear existing addresses that have been set
previously.
EMAILOPTIONS Sets the e-mail notification options.
Specify XML as the value to receive e-mail
notification in XML format. Not specifying any
value with this parameter will turn notification in
XML format off.
Reports the node number, node name, and heartbeat
information. You must switch to the log console
screen to see cluster statistics.
Managing Novell Cluster Services 53