Novell LINUX ENTERPRISE SERVER 11 - ADMINISTRATION Administration Manual page 252

The ctc Device
To add a ctc (IBM parallel CTC Adapter) interface to the installed system, start the
Network Devices > Network Settings module in YaST. Select one of the devices marked
IBM Parallel CTC Adapter to use as your read channel and click Configure. Choose
the Device Settings that fit your devices (usually this would be Compatibility Mode).
Specify both your IP address and the IP address of the remote partner. If needed, adjust
the MTU size with Advanced > Detailed Settings. Leave the network configuration
with Next and OK.
WARNING
The use of this interface is deprecated. This interface will not be supported in
future versions of SUSE Linux Enterprise Server.
The lcs Device
To add an lcs (IBM OSA-2 Adapter) interface to the installed system, start the Network
Devices > Network Settings module in YaST. Select one of the devices marked IBM
OSA-2 Adapter and click Configure. Enter the needed port number, some additional
options (see the Linux for IBM System z: Device Drivers, Features, and Commands
manual for reference,
linux390/index.html), your IP address and an appropriate netmask. Leave the
network configuration with Next and OK.
The IUCV Device
To add an iucv (IUCV) interface to the installed system, start the Network Devices >
Network Settings module in YaST. Select a device marked IUCV and click Edit. YaST
prompts you for the name of your IUCV partner (Peer). Enter the name (this entry is
case-sensitive) and select Next. Specify both the IP Address and the Remote IP Address
of your partner. If needed, Set MTU size on General tab. Leave the network configuration
with Next and OK.
238 Administration Guide
http://www.ibm.com/developerworks/linux/