Alesis HR-16 Instruction Manual page 68

2) Press and hold th6 CLOCK buton. The display will read:
MIDI &
3) Use the keypad or + and - buttons to select TAPE SYNC lN. The display will read:
4) Put the tape machine into PLAY. The MMT-8 will automatically start as soon as il
receives the ryngton9, causing any olher ssquencers connected lo it to play. Be careful
to. rcturn to the b.eginning ol the sync tone since the MMT-B will
aut6mhticaily
begin
playing any time that it receives the sync tone.
START / STOP FOOTSWITCH
The START/STOP footswitch jack is provided tor a momentary normally open lootswitch
that connects the jack's tip to hs sleeve (ground). Whil€ in stop; the footswit;h will function
like the play bulton and start a part or song from lhe beginning. While in play, thE
lootswitch acts like the slop button, and stops playing.
REMAINING MEMORY
Holding RECORD and pressing LENGTH causes the following display:
REMAINING MEMORY
1 0 0
This shows the amount of memory that has not b€en used. Note that some
operations may not be possible €ven though it seems that there is still a small
amount of memory available. This is du€ to lhe fact that the MMT-8 requires
€nough memory to duplicate a part beforo it can be recorded on, or length changed,
or offsel, etc. lf a large part is altempted to be altered when there is not enough
memory to complete lhe operation, th€ display will indicate that there is not
enough memory available to complete th€ op€ration.
C L E A R I N G M E M O R Y
To clear all ol the MMT-8'S memory and reinitialize all of its variables, turn power otl, press
and hold ERASE, PAGE UP, and PAGE DOWN, and turn on the power while holding
lhess bultons down lor 3 se@nds.
Alesis MMT-8 Instructions
......... Page 28