Configuring A Predefined Job's Properties; Configuring The Random Password Generator Job; Section 3.2, "Configuring The Schedule Driver Job," On; Section 3.3, "Configuring The Subscriber Channel Trigger Job," On - Novell IDENTITY MANAGER 3.6.1 - JOBS GUIDE Manual

Configuring a Predefined Job's
3
Properties
The following sections provide instructions for using iManager to configure the properties for the
five predefined jobs: Random Password Generator, Schedule Driver, Subscriber Channel Trigger,
Driver Health, and Password Expiration Notification. For each job, you can schedule the runtimes,
define the scope of objects that the job applies to, set the job-specific parameters, and determine the
methods used for results notification. For information about using Designer to configure a job, see
"Scheduling Jobs" in the
The steps assume that you've already added the job to a driver or driver set. If you have not, see
Chapter 2, "Adding a Predefined Job," on page
Section 3.1, "Configuring the Random Password Generator Job," on page 15
Section 3.2, "Configuring the Schedule Driver Job," on page 17
Section 3.3, "Configuring the Subscriber Channel Trigger Job," on page 18
Section 3.4, "Configuring the Driver Health Job," on page 19
Section 3.5, "Configuring the Password Expiration Notification Job," on page 21
3.1 Configuring the Random Password
Generator Job
The Random Password Generator job creates a random password for each object defined in the job's
scope. The password is generated by NMAS
references. Generally, each driver requires a password policy designed specifically for the connected
system. If you don't have a password policy to use, you need to create one before continuing with
the job configuration.
The job submits the generated passwords one at a time to the driver's Subscriber channel. The
Subscriber channel policies must take action on the passwords.
1 Make sure you've already added the job to the driver. If you haven't, see
Predefined Job," on page
2 On the General page, configure the following options:
Enable Job: Leave this option selected unless you don't want the job to run.
Delete the Job After it Runs Once: Select this option if you want the job to run one time only
and then be deleted.
Servers: Select the servers where you want the job to run. Multiple servers are available only if
the driver is running on multiple servers.
Email Server: To monitor the job, you (or others) can receive e-mail notifications whenever
certain results occur for the job. You configure e-mail notification on the Results page.
However, to enable this e-mail notification to work, you must first specify the e-mail server that
will be used to send the notifications. Click the
Notification Collection object or any other notfTemplateCollection object that defines an
SMTP mail server.
Designer 3.5 for Identity Manager 3.6 Administration
11.
to match a Password Policy object that the job
TM
11.
Guide.
Chapter 2, "Adding a
button to locate and select the Default

Configuring a Predefined Job's Properties

3
15