HIKVISION DS-KM9503 Manual

DS-KM9503
Network Main Sta on
1 1
ENGLISH
3
4 5
Diagram References
1
Appearance
1
1 Phone 2
2
Informa on Indicator
5
10 Unlock Bu on
14 Earphone Interface
19 Network Interface
Note: The appearance of the device varies according to different models. Refers to the actual device for
detailed informa on.
2
Terminal and Wiring
2
3
Please refer to the specific model.
HDMI: HDMI Signal Output
52
USB1/USB2/USB3: USB Interface
NO1/NO2: Alarm Output (Normally Open)
NC1/NC2: Alarm Output (Normally Close)
COM1/COM2: Common Interface
Note: USB3 is used to debugging only. It cannot connect to USB flash drive.
3
Installa on
It supports wall moun ng and table moun ng.
Installa on Accessory Descrip on
3.2
The table bracket is required to install the master sta on onto the wall or table.
The dimension of table bracket(Op onal) is shown.
Before You Start
Make sure the device in the package is in good condi on and all the assembly parts
are included.
The power supply the indoor sta on supports is 12 VDC. Please make sure your
6 7 6 8
Indicator(Reserved)
Microphone
6
Speaker Bu on
11
15 HDMI
20
Speaker
9 10 11
2
UD21582B
12 13
3 Power Indicator
7 Camera
12 Goose Neck Microphone
USB Interface
16 17
15 16 17 18
21 Fingerprint Module
14
3.1
LAN1: Network Interface (Support PoE)
LAN2: Network Interface (Reserved)
AIN1/AIN2: Alarm Input
485+/485-: RS-485 Communica on Interfaces
GND: Grounding
POWER: 12 VDC Power Input
Speaker
80
Unit:mm
3.3
4 Alarm Indicator
8 Screen 9 Call/Hang Up Bu on
13 SD Card Slot
Power Interface 18
19
3
20
Terminals
21
Main Sta on
Cover
1
2