Rear Panel Controls; Ac Power - Fishman SA220 User Manual

Rear Panel Controls

19. Channel 1 & 2 Effects Loop (Send) – Patch an external effect
(delay, reverb, chorus) through the send and return jacks for each channel.
Use a standard 1/4-inch shielded instrument cable to connect the effects
send to the input of the effect. This serial effects loop is located post-
EQ and is compatible with battery-operated stompbox-style effects
processors.
20. Channel 1 & 2 Effects Loop (Return) – This is the effects return
for each channel. Connect the Channel 2 return jack to the output of the
effect.
21. Channel 1 & 2 D.I. Out (Pre-EQ) – Use this output when you want
a fl at D.I. signal to go to the board. This pre-EQ output is always ground
isolated to prevent ground loop hum.
22. Tuner Out – Plug in an electronic tuner here. This output receives only
the Channel 1 signal and is independent of the mute, so you can tune with
the speakers and the XLR outs muted. The Tuner Out may also be used as
pre-EQ unbalanced D.I. out for Channel 1.
23. Tweeter Level – Set the front panel controls fl at and adjust the tweeter
level to where it sounds best to you.

24. AC Power

The SA220 has a universal power supply and can accept voltages from
around the world.
For amplifiers purchased in the USA, Canada and Mexico, plug in the
supplied detachable AC power cable.
For amplifiers purchased outside the USA and Canada, you will need to
supply your own detachable AC cable. This cable must have an IEC-style
320 connector at one end, and a male AC plug appropriate for your region
at the other.
Disconnect device is Mains Plug, which should remain readily operable.
10