Dell PowerConnect 2216 Technical Specifications Update

K5672A00.fm Page 1 Friday, February 20, 2004 3:45 PM
Dell™ PowerConnect™ 2200/2300 Series Ethernet Switches
Introduction
This document describes changes to the technical specifications of the PowerConnect 2200/2300
series Ethernet switches. This information replaces and supercedes that found in the Dell
PowerConnect 2216/2224/2324 Switches User's Guide. Where any differences exist in the
specifications or procedures between the two documents, the information in this document is
more accurate.
Product Specifications
• PowerConnect 2216
– Provides 16 ports supporting 10/100Base-T Ethernet.
– All ports support full- or half-duplex mode and PAUSE frames.
• PowerConnect 2224
– Provides 24 ports supporting 10/100Base-T Ethernet.
– All ports support full- or half-duplex mode and PAUSE frames.
• PowerConnect 2324
– Provides 24 ports supporting 10/100Base-T Ethernet and an additional 2 ports supporting
1000Base-T Ethernet.
– The 10/100Base-T ports support full- or half-duplex mode; the 1000Base-T ports support
full-duplex mode only.
– The 10/100Base-T ports support PAUSE frames; the 1000Base-T ports do not support
PAUSE frames.
Front-Panel Indicators
1000Base-T Ports Link/Activity (SPD/LNK/ACT) LED (PowerConnect 2324 only)
• Steady green — A 1000 Mbps link has been established, but no data is being transmitted
or received.
• Blinking green — A 1000 Mbps link has been established and data is being transmitted
or received.
• Off — No link has been established.
NOTE:
No link will will be detected if a 10/100Base-T device is connected to a 1000Base-T port (ports 25
and 26) on the PowerConnect 2324 switch.
February 2004
0K5672A00