Sealey VSE5037.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1. SAFETY
WARNING! Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective
‰
Equipment is available from your Sealey dealer.
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to
‰
when using tools.
DO NOT use tools if damaged.
8
Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
9
Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
9
Account for all tools, parts and components being used. DO NOT leave these in or near the engine. Return tools to suitable storage
9
after use.
▲ IMPORTANT ! These Instructions are provided as a guide only. Always refer to the vehicle manufactures' service instructions or a
proprietary manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The
‰
Operator / user must apply caution and common sense (good practical sense).
When timing an engine, always prevent the engine from being turned over. Use a notice and/or inhibit the engine.
9
WARNING! Incorrect or out of phase camshaft timing can result in contact between the valve head and the piston crown.This will
‰
cause damage to the engine.
Keep children and unauthorised persons away from the work area.
9
DO NOT attempt to start engine or move vehicle whilst in gear with the timing devices fitted.
8
Always display a warning notification on steering wheel when timing engine components.
9
2. INTRODUCTION
Suitable for setting and locking Fiat 2.3D JTD diesel engine (belt driven), Fiat 3.0D JTD diesel engine (chain driven) and Citroen/
Peugeot 3.0D Hdi diesel engine (chain driven). Set comprises camshaft setting pins, crankshaft locking pin and sensor locking pin.
3. CONTENTS
Item Part Number
1 VSE5037-V2-01
2 VSE5037-V2-02
3 VSE5037-V2-03
*These spares are sold as individual tools - not as
pairs or multiples. This information table provides
the Vehicle Manufacturers' Specialised Tool
references and the Sealey tool numbers covering
the relevant service application.
© Jack Sealey Limited
DIESEL ENGINE TIMING TOOL KIT FOR FIAT,
IVECO, CITROEN, PEUGEOT - 2.3D, 3.0D - BELT/
CHAIN DRIVE
VSE5037.V2
MODEL NO:
I
Description
Camshaft Setting Pins *2 per set
Crankshaft Locking Pin
Sensor Position Locking Pin
fig.1
Original Language Version
OEM Number
Fiat/Iveco
99360614
99360615/2.000.018.200
99360608/1.860.617.000
1
2
3
VSE5037.V2 Issue:2 04/03/25
OEM Number Citroen/
Peugeot
(-).0191/2.B
(-).0191/2.A
-
1