Configuring Wideband Cmts Components - Cisco WCM300 - Channel Bonded Cable Modem Implementation Manual

Wideband CMTS Configuration
All wideband channels used on a fiber node and all associated primary downstream channels on Cisco
uBR10-MC5X20 cable interface line cards must be configured to belong to the same virtual bundle
interface. For detailed information on this configuration task, see the "Configuring Wideband Channels
and Primary Downstream Channels as Virtual Bundle Members" section in the Cisco uBR10012
Universal Broadband Router SIP and SPA Software Configuration Guide.
Table 4-1
configuring the Cisco Cable Wideband Solution, Release 1.0, base CMTS components.
Table 4-1 Base CMTS Components Configuration: Where to Find Information
Solution Component
Cisco uBR10012 router
(general and feature-specific
configuration)
Performance Routing Engine 2 (PRE2)
Cisco uBR-MC5X20 line cards
Half-Height Gigabit Ethernet (HHGE)
network uplink line cards
The technical documentation set for the Cisco uBR10012 router includes many documents not shown in
Table 4-1
accessed from this web site area:
http://www.cisco.com/en/US/products/hw/cable/ps2209/tsd_products_support_series_home.html

Configuring Wideband CMTS Components

The wideband CMTS components are added to the base CMTS components to make the CMTS
wideband capable. This section provides overview information on configuring the wideband CMTS
components:
•
•
•
Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0
4-2
provides a list of the software configuration documents that are likely to be useful for
Where to Find Information
Release Notes for Cisco uBR10012 Universal Broadband Router for Cisco IOS
Release 12.3 BC
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
Cisco Cable Modem Termination System Feature Guide
Route Processor Redundancy Plus for the Cisco uBR10012 Universal
Broadband Router
Chapter 3, "Configuring Cable Interface Features for the Cisco uBR10012
Router," in the
Configuration Guide
"Cable Interface Bundling and Virtual Interface Bundling for the Cisco CMTS"
in the Cisco Cable Modem Termination System Feature Guide
"N+1 Redundancy for the Cisco Cable Modem Termination System" in the
Cisco Cable Modem Termination System Feature Guide
Configuring the Half-Height Gigabit Ethernet Line Card for the Cisco
uBR10012 Universal Broadband Router
that are useful for configuring this CMTS. The Cisco uBR10012 documentation set can be
Configuring the Wideband SIP and Wideband SPA, page 4-3
Configuring the Edge QAM Device Configuration, page 4-3
Configuring the Gigabit Ethernet Switch, page 4-5
Chapter 4
(which includes information on Cisco IOS Release 12.3(21)BC)
Cisco uBR10012 Universal Broadband Router Software
Implementing and Configuring the Solution
OL-10705-02