Cisco WCM300 - Channel Bonded Cable Modem Implementation Manual page 20

Base CMTS Components
Base CMTS Component Requirements
For the Cisco uBR10012 base system,
configurations for major components. The base system can be used as a DOCSIS 1.x/2.0 CMTS and can
be upgraded to a wideband CMTS. In the Recommended column, the number of components ensures
that the Cisco uBR10012 router has component redundancy where it is available.
Cisco IOS Release 12.3(21)BC or later is required for wideband cable functionality.
Table 2-1
Component
Performance Routing Engine 2 (PRE2)
Part number: ESR-PRE2/R
Timing, Communication, and Control Plus card (TCC+)
Part number: UBR10-TCC+-T1
DC Power Entry Modules (DC PEMs)
Part number:
UBR10-PWR-DC (Primary)
UBR10-PWR-DC\R (Redundant)
AC Power Entry Modules (AC PEMs)
Part number:
UBR10-PWR-AC (Primary)
UBR10-PWR-AC\R (Redundant)
Fan assembly module
Part number: UBR-10-FAN-ASSY
LCD module
Part number: UBR10-DSPL
uBR10-MC5X20S/U/H or uBR10-MC5X20U-D cable
interface line card
Part number:
uBR10-MC5X20S
uBR10-MC5X20U
uBR10-MC5X20H
uBR10-MC5X20U-D
Half-Height Gigabit Ethernet (HHGE) network uplink line
card
Part number: ESR-HH-1GE
Slot splitter card (One is required for each two HHGE line
cards.)
* The number of line cards and slot splitter cards required will vary depending on the set of services and
number of subscribers being supported.
Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0
2-4
Table 2-1
Cisco uBR10012 Base System: Minimum and Recommended Hardware
OR
Cable Interface Line Cards and Network Uplink Line Cards
Chapter 2 Cisco Cable Wideband Components
lists the minimum and recommended hardware
Minimum
1
1
1
1
1
1
1
1
Recommended
2
2
2
1
1
*
At least 2
*
At least 2
*
Varies
OL-10705-02