Table of Contents
Advertisement
Auto Configuration
RAS Active Time
RAS Precharge Time
RAS to CAS Delay
Write Recovery Time
CAS Latency Setting
¡ ü ¡ ý ¡ ú ¡ û
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
RAS Active Time
Select the number of SCLKs for an access cycle. The settings are: Auto (Default), 6T, 7T, 5T,
4T.
RAS Precharge Time
If an insufficient number of cycles is allowed for the RAS to accumulate its charge before
DRAM refresh, the refresh may be incomplete and the DRAM may fail to retain date. Fast
gives faster performance; and Slow gives more stable performance. This field applies only
when synchronous DRAM is installed in the system. The settings are: 7T, 6T and 5T.
RAS to CAS Delay
This field let's you insert a timing delay between the CAS and RAS strobe signals, used when
DRAM is written to, read from, or refreshed. Fast gives faster performance; and Slow gives
more stable performance. This field applies only when synchronous DRAM is installed in the
system. The settings are: 2T and 3T.
CAS Latency Setting
When synchronous DRAM is installed, the number of clock cycles of CAS latency depends
on the DRAM timing. The settings are: Auto (Default) 2T and 3T.
3-6-2 AGP Function Settings
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
Standard
7T
2T
2T
2T
2.5T
F6:Optimized Defaults
AGP Function Settings
26
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults
Advertisement
Table of Contents
