Table of Contents
Advertisement
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
hard disks to be both Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
2-6-2 Headers
(1)
Serial Port2 COM2 Header (9-pin) : COM2
(2)
Line-In/Out, MIC Header (9-pin): AUDIO
This header connect to Front Panel Line-In, Line-out, MIC connector with cable.
(3)
USB Port Headers (9-pin) : USB2, USB3
IDE2
Pin 1
Secondary IDE Connector
CO M2
Pin 1
Serial Port2 COM2 Header
AUDIO
2
10
Pin
9
1
Line-In/Out, MIC Headers
15
Note: Orient the read marking on the
COM2 ribbon cable to pin 1
Advertisement
Table of Contents
