Table of Contents
Advertisement
(6)
Speaker connector: SPKR
This 4-pin connector connects to the case-mounted speaker. See the figure below.
(7)
Power LED: PWR-LED
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(8)
Power switch: PWR BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
(9)
Wake On-LAN/Modem Headers (3-pin) : WOL, WOM
This connector connects to a LAN/Modem card with a WAKE ON-LAN/Modem output.
This connector power up the system when a wake up signal is received through the
LAN/Modem card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
PWR BTN
IDE LED
Speaker
System Case Connections
WOL
1
3
Wake-On-LAN Headers
18
WOM
1
3
Wake-On-Modem Headers
Advertisement
Table of Contents
