Anderic RRCM7500 Instruction Manual

Download this manual

3. Press & hold the [SETUP] key for about 3 seconds until the indicator light

remains on; release the key

Input the 4-digit code from the code list.

a. If valid – the indicator light will go out directly.

b. If invalid – the indicator light will blink three times quickly and go out; please

try inputting the code again.

ANDERIC RRCM7500 Instructions

Manual

Notice: For additional help, you may contact us at anderic.com. To

download a PDF version of this manual, please go to the link below

or scan QR code above. We recommend bookmarking below URL on

your mobile device so you can quickly retrieve the instructions

anytime you need it.

Anderic.com/

RRCM7500

Installing Batteries

Please insert two AA batteries into the battery compartment

behind the battery door on the back of the remote. You may

need to remove the screw securing the battery cover. Please

make sure to match polarities when installing the batteries.

Slide the battery cover down toward the bottom of the remote

to remove it, then replace it after installing the batteries. The

battery cover screw is optional and is not needed to secure the

battery cover to the remote.

Optional security cable (sold separately)

This remote has an optional security cable (sold separately)

attachment. You can purchase this security cable from

Anderic.com/CBL01. Part number: CBL01.

Programming - Code Input Method

Turn on the device you want to control.

Find the corresponding brand code from the attached code-

list and write it down.

Need help?

Do you have a question about the RRCM7500 and is the answer not in the manual?

Page 1 ANDERIC RRCM7500 Instructions Manual Notice: For additional help, you may contact us at anderic.com. To download a PDF version of this manual, please go to the link below or scan QR code above. We recommend bookmarking below URL on your mobile device so you can quickly retrieve the instructions anytime you need it.
Page 2 Check to see if most of the keys work to control your device; if not, please try another code under the same brand & repeat all steps. You may also try the “Code search method.” Note: During the programming mode, not pressing any button for 20 seconds will cause the remote to exit the programming mode.
Page 3 1. Press & hold the [SETUP] key for about 3 seconds until the indicator light remains on; release the key. 2. Press the [VOL+] key, and the indicator light blinks once and remains illuminated. 3. Press the device key [RED-COLORED] for the TV or [GREEN-COLORED] for the set-top box.
Page 4 Go to Anderic.com/RRCM7500 for help and support. Anderic is a registered trademark of Dan’s Electronics Etc., Inc. All brands mentioned in this document are registered trademarks of their respective owners. Dan’s Electronics Etc., Inc. has no affiliation with other brands.