Advertisement

Quick Links

The Anderic KTN828 works with most air condi6oners that require a remote control.
Note: Sliding the door panel on the front of the remote will expose the
rest of the keys, including the "SELECT" key used for programming. Also,
note the numbers on the bo=om le> corner of each key. These keys are for
entering the codes. See the sec6on below for programming using the code
input method.
Installing BaJeries
To install ba=eries, simply slide off the ba=ery cover on the back of the
remote. Please install 2 AAA ba=eries, no6ng the polarity marks in the
compartment. Replace the cover.

Programming using the code input method

1. Take note of the codes beside your AC's brand in this
manual's code sec6on.
2. Press the "SELECT" key, and the code sec6on on the
screen will flash.
3. Enter the first 4-digit code beside your brand from the
code sec6on.
a. The remote should now operate AC; if it does
not, please repeat step 2 with the following
code from the code sec6on.
b. A>er you find a code that works, try other
func6on keys to see if they work. If you feel
the other keys should be working, you can try
a different code to see if a be=er code works
more fully.

Programming using auto-search method

If you do not know the brand of your air condi6oner, or if your
brand doesn't appear in the code table, please operate as per
the following steps:
1. Aim the remote control at your air condi6oner during
this process.
Anderic KTN828 Opera1ng Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KTN828 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Anderic KTN828

  • Page 1 Anderic KTN828 Opera1ng Manual The Anderic KTN828 works with most air condi6oners that require a remote control. Note: Sliding the door panel on the front of the remote will expose the rest of the keys, including the "SELECT" key used for programming. Also, note the numbers on the bo=om le>...
  • Page 2 2. Press the "SELECT" key for 5 seconds and then release; the remote control has entered auto-search status. The remote is now sending codes con6nuously. 3. When AC responds, immediately press any key on the remote to save the current code quickly.
  • Page 3 If the remote is to be stored and not used for a long 6me, please remove the ba=eries to avoid the possibility of corrosion or leakage due to the ba=eries going bad. ANDERIC® is a registered trademark of Dan's Electronics Etc., Inc. For support, please visit Anderic.com/KTN828 or call 1-855-263-3742.

Table of Contents