Asko T701 Quick Start Manual page 2

1. Press the Power button to turn on the machine.
2. Load the laundry into the dryer.
3. Clean the lint filter (see below).
4. Check that the door is clear of laundry then close it firmly.
5. Turn the Program Control knob to the desired program (Dry or Normal Dry) or Timed dry (90, 60, or 30 minutes).
6. If you select Timed dry, turn the Temperature Control knob to the desired setting (Normal, Low, or Air Fluff).
7. Make your program option selections (e.g., Anti-crease).
8. Press Start. The machine will start.
You have the option to turn the buzzer on or off. If you turn the buzzer on, it will sound for three seconds when the
program is complete. Note: The Cool-down button must also be pressed in for the buzzer to sound.
The Anti-crease option is designed to prevent garments from becoming wrinkled if you're unable to remove them
from the dryer right away. When you select this option, after the drying program is complete the drum will continue
to rotate for three seconds every minute until the door is opened or one hour has passed. If the buzzer is on, it will
sound each time the anti-crease program activates.
Press this button in to select a Normal Cooling cycle, which is 18 minutes. Release this button to select a Quick
Cooling cycle, which is 9 minutes. Please note that Quick Cooling cannot be selected with the Anti-crease option.
To interrupt a program, simply open the door. The dryer will stop tumbling automatically. To continue the program, close the door and press
Start. The program will continue from the point it was interrupted.
To cancel a program, turn the Program Control knob clockwise until the dryer stops or press the Power button to turn off the power.
Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each
load to ensure maximum air flow and prevent possible overheating. To clean the filter, follow the
steps below:
1. Grasp the handle and pull it toward you.
2. Remove the filter from the holder by pulling it up.
3. Open the filter and gently brush away any lint.
4. Fold the filter together and return it to the holder on the door.
5. Push the holder in until it snaps into place
NOTE:
The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is
clogged or the fan needs to be cleaned. If the dryer shuts off during a program, check the lint filter first. If it is clean, it could be the fan needs
to be cleaned. See page 3 in your Use and Care Guide for more details.
Refer to your Use and Care Guide for additional programming and operational information as well as care and cleaning instructions.
We recommend that you clean the lint filter after every load.