Advertisement
Quick Links
Advertisement
Related Manuals for rollease acmeda Yuki
Summary of Contents for rollease acmeda Yuki
- Page 1 Yuki INSTALLATION MANUAL v1.2 | June 2025...
- Page 2 APPENDIX A: DOCUMENT CHANGE NOTES ....................9 DISCLAIMER INTRODUCTION This installation manual for Yuki system has been produced by Rollease Acmeda to supply the necessary information for the safe and correct installation of Yuki system. DISCLAIMER Rollease Acmeda has used reasonable care in preparing the information included in this document, but makes no representations or warranties as to the completeness or accuracy of the information.
- Page 3 TOOLS REQUIRED Drill Drill Bits Phillips Head / Flat Head Screwdriver Suitable Fasteners Step Drill Spirit Level Measuring Tape Pencil Allen Key Set Yuki Installation Manual | v1.2 | June 2025 Page. 3 © Copyright All Rights Reserved Rollease Acmeda...
- Page 4 Before installing, please read & ensure you understand the safety information and installation instructions as defined in this installation manual. • If you do not fully understand these instructions, contact Rollease Acmeda for clarification before installing. • The Installer is responsible to ensure that all installation personnel have been adequately trained on the safe & correct installation and operation.
- Page 5 THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF IN "MM" ITEM CODE: ROLLEASE ACMEDA. ANY REPRODUCTION IN PART OR WHOLE WITHOUT THE REV. WRITTEN PERMISSION OF ROLLEASE ACMEDA IS PROHIBITED. TOP FIX Define the distance of the brackets and position them on the awning assembly frame.
- Page 6 Insert the square nut Insert the square nut into the slot (B). into the slot (C). NOTE Set the regulating cylinder at minimum (D). Yuki Installation Manual | v1.2 | June 2025 Page. 6 © Copyright All Rights Reserved Rollease Acmeda...
- Page 7 Ensure the conveyor is attached to the centre of the awning using #8 X 16mm to 25mm screws. • Pre-drilling into plastic is recommended. Loosen the side screw. 10mm Allen Key Yuki Installation Manual | v1.2 | June 2025 Page. 7 © Copyright All Rights Reserved Rollease Acmeda...
- Page 8 If they are not parallel, tighten or slacken the dowel (E) in the lever using 3mm Allen Key. Yuki Installation Manual | v1.2 | June 2025 Page. 8 © Copyright All Rights Reserved Rollease Acmeda...
- Page 9 APPENDICES APPENDIX A: DOCUMENT CHANGE NOTES REVISION CHANGES v1.2 | June 2025 Updated layout and some illustrations. Yuki Installation Manual | v1.2 | June 2025 Page. 9 © Copyright All Rights Reserved Rollease Acmeda...
Need help?
Do you have a question about the Yuki and is the answer not in the manual?
Questions and answers