Advertisement
Advertisement
Table of Contents
Related Manuals for rollease acmeda YUKI
Summary of Contents for rollease acmeda YUKI
- Page 1 YUKI INSTALLATION MANUAL v1.0 | February 2024...
- Page 2 Information is supplied upon the condition that the persons receiving the information will make their own determination as to its suitability for their purposes prior to use. Rollease Acmeda assumes no liability whatsoever for any damages incurred by you resulting from errors in or omissions from the information included herein.
-
Page 3: Section 1 | Warranty
SECTION 1 | WARRANTY WARRANTY Rollease Acmeda provide a 5 year hardware warranty against defects to the original purchaser [the fabricator/manufacturer]. The hardware warranty is not to be transferred to the end consumer. The hardware warranty is limited to the repair or resupply of defective hardware components to the fabricator/manufacturer only. -
Page 4: Section 2 | Prior To Installation
• If you do not fully understand these instructions, contact Rollease Acmeda for clarification before installing • The Installer is responsible to ensure that all installation personnel have been adequately trained on the safe &... -
Page 5: Section 3 | Installation
Define the distance of the brackets and position them on the awning assembly frame L is the width of the awning Use anchors M10, or at most M12 FIXING BRACKET Page 5 YUKI | Installation Manual | v10 | February 2024 ©Copyright All Rights Reserved Rollease Acmeda... - Page 6 CEILING MOUNT NOTE: For roof-mounted awnings, the support must be fitted vertically and the square nut inserted in the slot at the top Page 6 YUKI | Installation Manual | v10 | February 2024 ©Copyright All Rights Reserved Rollease Acmeda...
-
Page 7: Awning Installation
SECTION 3 | INSTALLATION AWNING INSTALLATION Install the awning on the brackets fixed to the wall Secure the awning with the screws Page 7 YUKI | Installation Manual | v10 | February 2024 ©Copyright All Rights Reserved Rollease Acmeda... -
Page 8: Section 4 | Adjusting The Awning
After adjusting the pitch, check the terminal bar is perfectly horizontal NOTE: • After adjusting the pitch, firmly tighten the side screw [1] Page 8 YUKI | Installation Manual | v10 | February 2024 ©Copyright All Rights Reserved Rollease Acmeda... - Page 9 If they are not parallel, tighten or loosen the screw in the arm support (3mm Allen Key) Always support the weight of the arms when adjusting the awning. Page 9 YUKI | Installation Manual | v10 | February 2024 ©Copyright All Rights Reserved Rollease Acmeda...
Need help?
Do you have a question about the YUKI and is the answer not in the manual?
Questions and answers