Idex Band-it S03869 Instruction Manual

Instruction
Manual
Introduction:
The S03869 Center Punch Tool installs BAND-IT 3/8" and 5/8", 201 Stainless
Steel and Galvanized Carbon Steel clamps.
Table of Contents:
1. Introduction & Safety Practices
2. Operating Instructions
3. Repair Parts List & Warranty
Safety Practices:
1. Read this manual and become familiar with the tool before use.
2. Protective eyewear should be worn during use.
3. Wear appropriate gloves for handling steel.
4. When applying clamps, care should be taken to insure fingers are not in contact with
the clamp during installation.
5. Never attempt to clamp objects which have the potential to burst, shatter or
otherwise cause bodily harm.
6. Do not use tool on live electrical sources.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 1 of 2
S03869
Center Punch Tool
Document # P06788 rev. F
© Copyright
BAND-IT-IDEX, Inc. 2025
All rights reserved