Sealey ROADSTART PBI2212GS Manual
Sealey ROADSTART PBI2212GS Manual

Sealey ROADSTART PBI2212GS Manual

2300a 12v emergency jump starter 4600a 12/24v emergency jump starter
Hide thumbs Also See for ROADSTART PBI2212GS:

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
Keep in dry area
protect from rain
1.
SAFETY
1.1.
ELECTRICAL SAFETY FOR USE OF CHARGER
WARNING! It is the user's responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using.
9
Inspect power supply leads, plugs and all electrical connections for wear and damage.
9
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9
DO NOT use worn or damaged cables, plugs or connectors.
8
Ensure that any faulty item is repaired or replaced immediately by a Sealey qualified technician.
9
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
9
Sealey recommend that an RCD (Residual Current Device) is used with all electrical products.
9
Important: Ensure that the voltage rating on the appliance suits the mains power supply.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
Uncoil the cable between charger and the RoadStart®.
9
WARNING! DO NOT use any other type of charger with this product, other than the supplied mains or car charger. Failure to observe
this warning could result in injury and or fire and will invalidate the warranty.
DO NOT try to take the charger plug apart.
8
DO NOT use the charger plug to charge or power any other electrical item.
8
DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only).
8
1.2.
BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
Ensure the internal battery is fully charged before initial use.
9
DO NOT move/handle/use the Road Starter® when it is being charged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Only use charger supplied. Before storage, fully recharge
8
the battery, subsequently recharge the battery at least once every six months of non-use.
DANGER! RISK OF EXPLOSIVE GASES. PREVENT FLAMES AND SPARKS. PROVIDE ADEQUATE VENTILATION DURING
CHARGING. WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE
GASES DURING NORMAL OPERATION. FOR THIS REASON, IT IS IMPORTANT THAT YOU FOLLOW THESE INSTRUCTIONS
EACH TIME YOU USE THE ROADSTART®.
It is very important to read and follow these instructions carefully, each time you use the Roadstart..
Follow these instructions and those published by the battery and vehicle manufacturers, and the maker of any equipment you intend to
use in the vicinity of the battery. Remember to review warning marks on all products and on engines.
WARNING! Modern vehicles contain extensive electronic systems.
You are required to check with the vehicle Manufacturer, for any specific instructions regarding the use of this type of equipment on each
vehicle. No liability will be accepted for damage / injury, where this product is not used in accordance with all instructions.
© Jack Sealey Limited
2300A 12V ROADSTART® EMERGENCY JUMP STARTER
4600A 12/24V ROADSTART® EMERGENCY JUMP STARTER
MODEL NO's:
Wear protective
Electrical shock
gloves
hazard
Original Language Version
PBI2212GS, PBI4424GS
Warning
Warning:
explosive
corrosive
material
substance
PBI2212GS
Keep away
Use in well
from sources of
ventilated areas
ignition
PBI4424GS
Issue 5
16/05/25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROADSTART PBI2212GS and is the answer not in the manual?

Questions and answers

Summary of Contents for Sealey ROADSTART PBI2212GS

  • Page 1 PBI2212GS, PBI4424GS MODEL NO’s: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Personal Precautions

    1.7m Fuse Rating: 300A 500A Nett Weight: 9.5kg 17.5kg Peak Amps: 2300A 4600A(12V)/2300A(24V) Plug Type: 3-Pin 3-Pin Power Supply Cable Length: 2m Starting Current: 900A 1800/900A Voltage: 12/24V PBI2212GS PBI4424GS Issue 5 16/05/25 Original Language Version © Jack Sealey Limited...
  • Page 3: Charging The Internal Battery

    See troubleshooting section for more information. BAD BATTERY (red) LED lit: The charger has detected a problem with the battery. See troubleshooting section for more information. PBI2212GS PBI4424GS Issue 5 16/05/25 Original Language Version © Jack Sealey Limited...
  • Page 4: Connecting To A Battery

    1. Open the protective cover of the DC power outlet on the front of the Roadstart®. 2. Plug the device into the outlet and turn the device on (if required). PBI2212GS PBI4424GS Issue 5 16/05/25 Original Language Version © Jack Sealey Limited...
  • Page 5: 12. Troubleshooting

    Roadstart®. See LED Indicators section of this manual. The vehicle’s battery is defective. Have the battery checked. The fuse has blown. Replace the power fuse (See section 9.5). PBI2212GS PBI4424GS Issue 5 16/05/25 Original Language Version © Jack Sealey Limited...
  • Page 6: Environment Protection

    BATTERY REMOVAL SEE SECTION 10.9 Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.

This manual is also suitable for:

Roadstart pbi4424gs

Table of Contents