Onkyo HT-S5500 Instruction Manual page 28

1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV receiver
is connected.
2
Set the speaker setup microphone at the Main
Listening Position , and connect it to the SETUP
MIC jack.
SETUP MIC jack
Speaker setup microphone
The speaker setting menu appears.
Note
• The on-screen menus appear only on a TV that is connected
to the HDMI OUT. If your TV is connected to other video
outputs, use the AV receiver's display when changing
settings.
3 When you've finished making the settings, press
ENTER.
2EQ: Auto Setup
SurrBk/FrontHigh < SurrBack >
Perform the "Sp Config (Speaker Configuration)"
according to your speaker configuration:
(➔ page 42)
– "SurrBk/FrontHigh"
4
Use / to select "Audyssey Quick Start" or
"Audyssey 2EQ Full Calibration", and then press
ENTER.
5
Press ENTER.
Audyssey 2EQ
starts.
Test tones are played through each speaker as
Audyssey 2EQ Room Correction and Speaker Setup
runs. This process takes a few minutes. Please refrain
from talking during measurements and do not stand
between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey 2EQ Room Correction and Speaker
Setup, unless you want to cancel the setup.
If you select "Audyssey Quick Start", you will go to
step 8.
6
Place the speaker setup microphone at the next
position, and then press ENTER.
Audyssey 2EQ performs more measurements. This
takes a few minutes.
7
When prompted, repeat step 6.
8
Use / to select an option, and then press ENTER.
Audyssey
The options are:
Save:
Save the calculated settings and exit
Audyssey 2EQ Room Correction and Speaker
Setup.
Cancel:
Cancel Audyssey 2EQ Room Correction and
Speaker Setup.
® Room Correction and Speaker Setup
2EQ: Auto Setup Audyssey
<- Review Speaker Configuration ->
Subwoofer : Yes
Front : Small
Center : Small
Surround : Small
Front High : None
Surr Back : Small
Surr Back Ch : 2ch
Crossover : 100Hz
Save
Cancel
En-28
Turning On & Basic Operations
Tip
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using / .
9
Use / to select a target, and use
the setting.
After the results of Audyssey 2EQ have been saved,
the menu will display the "Audyssey"
"Dynamic EQ" (➔ page 46), "Dynamic Volume"
(➔ page 47) settings.
Note
• When "Audyssey Quick Start" has been used for
measurement, "Audyssey" cannot be selected.
• These settings are applied to all input selectors.
10
Press ENTER.
11 Disconnect the speaker setup microphone.
Note
• You can cancel Audyssey 2EQ Room Correction and Speaker
Setup at any point in this procedure simply by disconnecting the
setup microphone.
• Do not connect or disconnect any speakers during Audyssey 2EQ
Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey 2EQ Room Correction and Speaker Setup starts.
• Changes to the room after Audyssey 2EQ Room Correction and
Speaker Setup requires you run Audyssey 2EQ Room Correction
and Speaker Setup again, as room EQ characteristics may have
changed.
/ to change
(➔ page 46),