D.10.2. Rhn Satellite::execution Time; D.10.3. Rhn Satellite::interface Traffic; D.10.4. Rhn Satellite::latency - Red Hat NETWORK SATELLITE 5.3.0 Reference Manual

Appendix D. Probes
• Space Available — The file size available to the current file system.
Field
Device Pathname*
Critical Maximum File System Used
Warning Maximum File System Used
Critical Maximum Space Used
Warning Maximum Space Used
Critical Maximum Space Available
Warning Maximum Space Available
Table D.63. RHN Satellite::Disk Space settings

D.10.2. RHN Satellite::Execution Time

The RHN Satellite::Execution Time probe monitors the execution time for probes run from a Satellite
and collects the following metric:
• Probe Execution Time Average — The seconds required to fully execute a probe.
Field
Critical Maximum Probe Execution Time Average
Warning Maximum Probe Execution Time Average
Table D.64. RHN Satellite::Execution Time settings

D.10.3. RHN Satellite::Interface Traffic

The RHN Satellite::Interface Traffic probe monitors the interface traffic on a Satellite and collects the
following metrics:
• Input Rate — The amount of traffic in bytes per second the device receives.
• Output Rate — The amount of traffic in bytes per second the device sends.
Field
Interface*
Timeout (seconds)*
Critical Maximum Input Rate
Critical Maximum Output Rate
Table D.65. RHN Satellite::Interface Traffic settings

D.10.4. RHN Satellite::Latency

The RHN Satellite::Latency probe monitors the latency of probes on a Satellite and collects the
following metric:
• Probe Latency Average — The lag in seconds between the time a probe becomes ready to run
and the time it is actually run. Under normal conditions, this is generally less than a second. When
288
Value
/dev/hda1
Value
Value
eth0
30