Red Hat NETWORK SATELLITE 5.3.0 Reference Manual page 161

1. From the Monitoring
distinguishable name for the Probe Suite. You may also choose to add a brief description of the
Suite. Click the Create Probe Suite button to continue.
2. Add and configure the probes that comprise the Suite. Click the create new probe link in the
upper right.
Section 7.4.2.9.5.2, "System Details
3. As described in
", configure the probe and click the Create Probe button in the lower right. Repeat this process
until all desired probes have been added.
Note
Sendmail must be configured correctly on your RHN Satellite and each client system
to which the Probe Suite is applied must have the rhnmd daemon installed and
running. Refer to the RHN Satellite 5.2.0 Installation Guide for additional information.
4. Add the systems to which the Probe Suite applies. Click the add systems to probe suite link in
the upper right of the screen to continue.
5. The next page displays a list of all systems with Monitoring entitlements. Check the box to the left
of the system(s) to which you wish to apply the Probe Suite, select the monitoring scout you wish
to use, and click the Add systems to probe suite button to complete the creation of the Probe
Suite.
You can either delete or detach probes from the suite. Detaching a probe disassociates the probes
from the suite and converts them to system-specific probes for the specified system. This means that
changes to the detached probes only effect that system. Deleting a probe removes it from the Suite for
all systems.
To remove probes from the Probe Suite:
1. From the Monitoring
2. Select the Probes sub-tab.
3. Check the box next to the probe you wish to remove.
4. Click the Delete probes from Probe Suites button.
You may also remove a system from the Probe Suite. There are two ways to accomplish this.
The first method is to detach the system from the Probe Suite. When you do so, the system
still has the same probes assigned to it. However, you now have the ability to configure these
probes individually without affecting any other systems. For more information about removing
probes from an individual system, refer to
To detach a system from the suite:
1. From the Monitoring
Probe Suites page, select the create probe suite link. Enter an easily
Probe Suites page, click on the title of the Probe Suite you wish to alter.
Section 7.4.2.9.5.2, "System Details
Probe Suites page, click on the title of the Probe Suite you wish to alter.
Monitoring —
Monitoring —
Probe Suites
".
149