System Groups - Red Hat NETWORK ENTERPRISE - USER REFERENCE GUIDE 2.2 User Reference Manual

Chapter 4. Red Hat Network Website

4.4.3. System Groups

The System Groups page allows all RHN Enterprise users to view the System Groups list. Only
Organization Administrators may perform the following additional tasks:
1. Create system groups. (Refer to Section 4.4.3.1 Creating Groups.)
2. Add systems to system groups. (Refer to Section 4.4.3.2 Adding and Removing Systems in
Groups.)
3. Remove systems from system groups. (Refer to Section 4.4.2.6 System Details.)
4. Assign system group permissions to users. (Refer to Section 4.8 Users.)
As shown in Figure 4-4, the System Groups list displays all of your system groups.
Figure 4-4. System Group List
The System Groups list contains several columns for each group:
Select — Enables you to add groups to the System Set Manager. To select groups, mark the
•
appropriate checkboxes and click the Updatebutton below the column. Selected groups are added
to the System Set Manager. After adding groups to the System Set Manager, you can use it to
perform actions on them simultaneously. To add an intersection of groups, select them and click the
Work with Intersection button. To add a union of groups, select them and click the Work with
Union button. Refer to Section 4.4.4 System Set Manager for details.
Status — Shows which type of Errata Alerts are applicable to the group or confirms that it is up-
•
to-date. Clicking on a group's status icon takes you to the Errata tab of its System Group Details
page. Refer to Section 4.4.3.3 System Group Details for more information.
The status icons call for differing degrees of attention:
— All systems within group are up-to-date
•
— Critical Errata available, update strongly recommended
•
51