Netscape DIRECTORY SERVER 7.0 - DSML GATEWAY Introduction Manual page 4

Activating the Gateway
Install Directory Server.
2.
The DSML gateway is installed with Directory Server. It must be activated
separately; see step 3. The DSML Gateway can run simultaneously with the
other two gateways that are installed with Directory Server; however, it does
not interact with them.
Enable the the gateway.
3.
See "Activating the Gateway" for instructions on how to enable the gateway
and for the command-line utilities available.
Modify the configuration files.
4.
During installation, the files relevant to the DSML gateway are placed in
serverRoot/clients/dsmlgw
dsmlgw.cfg
application to suit your organization.
The gateway connects to the default port (
gateway can also point to a different server and port; you can configure this
at installation or when moving or creating instances of the gateway. This is
addressed in "Configuring the DSML Gateway."
DSML gateway can be configured to point to the Directory Server or the
Admin Server, to run from a different port, and to allow read-write access.
The default settings allow read-only access to the directory with the server set
as the Directory Server. See "Configuring the DSML Gateway" for detailed
information on configuration parameters. It is recommended that you not
change the default settings.
Activating the Gateway
The DSML gateway is installed with Directory Server. To enable it, do the
following:
Stop the server with the
1.
4 Netscape Directory Server DSML Gateway • October 2004
. The configuration information is stored in
. You can modify desired settings in the file and customize the
./stop-admin
) of Directory Server. The
389
command.