Netscape DIRECTORY SERVER 6.02 Installation Manual page 37

The program then asks you for the System User and the System Group
18.
setup
names. Enter the identity under which you want the servers to run.
For more information on the user and group names that you should use when
running Netscape servers, see "Deciding the User and Group for Your
Netscape Servers (UNIX only)," on page 14.
For the configuration directory, select the default if this directory will host
19.
your
o=NetscapeRoot
the contact information for the configuration directory.
If the server you are currently installing is not the configuration directory, then
the configuration directory must exist before you can continue this installation.
The program then asks if the server you are currently installing will be
20.
setup
the one for your user data. For most cases, you can select the default. However,
if you intend this server instance to be used as a configuration directory only,
then you should enter
For the Directory Server port, select the default (389) unless you already have
21.
another application using that port.
For the Directory Server Identifier, enter a unique value (normally the default
22.
is sufficient).
This value is used as part of the name of the directory in which the Directory
Server instance is installed. For example, if your machine's host name is
, then this name is the default and selecting it will cause the
phonebook
Directory Server instance to be installed into a directory labeled
slapd-phonebook
CAUTION The Directory Server identifier must not contain a period. For
example,
For Configuration Directory Administrator ID and password, enter the name
23.
and password that you will log in as when you want to authenticate to the
console with full privileges.
tree. Otherwise, enter
.
Yes
.
example.server.com
Chapter 3
Using Typical Installation
. You will then be asked for
Yes
is not a valid server identifier name.
Using Express and Typical Installation 37