Tuning Tcp Parameters - Netscape DIRECTORY SERVER 6.02 Installation Manual

CAUTION This parameter should not be raised above 4096 without first
consulting your Sun Solaris support representative as it may affect
the stability of the system.

Tuning TCP Parameters

By default, the TCP/IP implementation in a Solaris kernel is not correctly tuned for
Internet or Intranet services. The following
inspected and, if necessary, changed to fit the network topology of the installation
environment.
The
tcp_time_wait_interval
that a TCP connection will be held in the kernel's table after it has been closed. If its
value is above 30000 (30 seconds) and the directory is being used in a LAN, MAN
or under a single network administration, it should be reduced by adding a line
similar to the following to the
ndd -set /dev/tcp tcp_close_wait_interval 30000
The
tcp_conn_req_max_q0
maximum backlog of connections that the kernel will accept on behalf of the
Directory Server process. If the directory is expected to be used by a large number
of client hosts simultaneously, these values should be raised to at least 1024 by
adding a line similar to the following to the
ndd -set /dev/tcp tcp_conn_req_max_q0 1024
ndd -set /dev/tcp tcp_conn_req_max_q 1024
The
tcp_keepalive_interval
packets sent by Solaris for each open TCP connection. This can be used to remove
connections to clients that have become disconnected from the network.
The
tcp_rexmit_interval_initial
server performance testing on a LAN or high speed MAN or WAN. For operations
on the wide area Internet, its value need not be changed.
The
tcp_smallest_anon_port
that can be made to the server. When
4096, this value should be decreased, by adding a line similar to the following to
the
/etc/init.d/inetinit
ndd -set /dev/tcp tcp_smallest_anon_port 8192
The
tcp_slow_start_initial
predominately be using the Windows TCP/IP stack.
/dev/tcp
in Solaris 8 specifies the number of milliseconds
/etc/init.d/inetinit
and
tcp_conn_req_max_q
/etc/init.d/inetinit
specifies the interval in seconds between keepalive
value should be inspected when performing
controls the number of simultaneous connections
rlim_fd_max
file:
parameter should be inspected if clients will
Chapter 2
Operating System Requirements
tuning parameters should be
file:
parameters control the
file:
has been increased to above
Computer System Requirements 27