Advertisement
Quick Links
Advertisement
Related Manuals for ROBO R2
Summary of Contents for ROBO R2
- Page 1 Quick start guide 日本語 robo3d.com/getstarted 汉语...
- Page 2 Make it all happen — now. Make the imagined. Register your Robo R2 To activate your warranty and receive all the latest information about your Robo R2, visit: robo3d.com/register See full terms and conditions of warranty at: robo3d.com/warranty Owner’s 24/7 Customer...
- Page 3 Auxillary port © 2017 Robo 3D Inc., San Diego, California. All rights reserved. Robo, Robo 3D, Robo R2, Robo R2 are trademarks or registered trademarks and are the properties of Robo 3D Inc. Registered in the USA and other countries.
- Page 4 Control each print with the Robo App Download the free Robo App and easily control each print right from your Apple iOS device. Multiple printers, one app Control multiple prints and printers. Cloud storage integration Connect to cloud based libraries and access thousands of 3D models.
-
Page 5: Initial Setup
(do not pull straight up). Connect power adapter and cable to Turn on Robo R2 power switch. Robo R2, then plug into power outlet. Note: Only use power adapter and cable provided... - Page 6 It is highly recommended to connect Robo R2 to Wi-Fi — this Step 2 Connect to Wi-Fi allows you to directly print from the Robo App or Chromebook. Select UTILITIES on touchscreen. Select NETWORK. Select CONFIGURE WI-FI. Robo R2 will scan available networks.
- Page 7 UPDATE and the update will begin. Always keep your Robo R2 up-to-date Following this process regularly is the best way to confirm your machine is operating with the most recent advancements and functionalities available whenever we release them. Step 4...
- Page 8 189.1°C 56.9°C Z Offset Wizard Z Offset 1/4 Z Offset Wizard Z Offset 1/4 Use the Z Offset Wizard to properly set the home Moving Z Axis to minimum position. The wizard will position for the Z value of your printer. go to the next step once this is complete.
-
Page 9: Load Filament
Step 5 Load filament Press to open the topmost filament Insert filament feed tube into Hang filament spool onto spool spool (filament spool holder 1). filament sensor block. holder 1. Unroll at least 12” (30 cm) of filament Select UTILITIES on touchscreen. - Page 10 Select the type of filament you and follow along with the steps spool into your printer. are using. on-screen. Note: Robo R2 works with a wide range of non Robo filaments. 10. Push SELECT to choose the 11. The extruder will now heat up to 12.
-
Page 11: Test Print
The file will begin printing. Note: While the Robo R2 print bed is removable, remember that it may be You have the option to select PAUSE too hot to touch when you try and remove it from the printer. Please be... - Page 12 To access, first ensure your Robo R2 is connected to Wi-Fi, then connect to your Robo R2 from any web-enabled device on the same Wi-Fi network by going to the Robo R2 IP address. You can find the IP Print from USB drive on your Robo R2 in: Utilities >...
Need help?
Do you have a question about the R2 and is the answer not in the manual?
Questions and answers