Kernel Modules Loaded; Setup Process - Red Hat GFS 6.0 Administrator's Manual

144
C.2.2. Kernel Modules Loaded
Each node must have the following kernel modules loaded:
• gfs.o
•
lock_harness.o
•
lock_gulm.o
•
pool.o
C.2.3. Setup Process
The setup process for this example consists of the following steps:
1. Create pool configurations for the two file systems.
Create pool configuration files for each file system's pool:
and
pool_gfs02
poolname pool_gfs01
subpools 1
subpool 0 0 1
pooldevice 0 0 /dev/sda2
poolname pool_gfs02
subpools 1
subpool 0 0 1
pooldevice 0 0 /dev/sdb1
2. Create a pool configuration for the CCS data.
Create a pool configuration file for the pool that will be used for CCS data. The pool does not
need to be very large. The name of the pool will be
, followed by
alpha
poolname alpha_cca
subpools 1
subpool 0 0 1
pooldevice 0 0 /dev/sda1
3. Use the
pool_tool
n01# pool_tool -c pool_gfs01.cf pool_gfs02.cf alpha_cca.cf
Pool label written successfully from pool_gfs01.cf
Pool label written successfully from pool_gfs02.cf
Pool label written successfully from alpha_cca.cf
4. Activate the pools on all nodes.
Note
This step must be performed every time a node is rebooted. If it is not, the pool devices will not
be accessible.
Activate the pools using the
n01# pool_assemble -a
alpha_cca assembled
pool_gfs01 assembled
pool_gfs02 assembled
n02# pool_assemble -a
for the second file system. The two files should look like the following:
). The file should look like the following:
_cca
command to create all the pools as follows:
pool_assemble -a
<-- Activate pools
<-- Activate pools
Appendix C. Basic GFS Examples
pool_gfs01
. (The name of the cluster,
alpha_cca
command for each node as follows:
for the first file system,