Virtual Servers - Red Hat ENTERPRISE LINUX 4 Manual

Chapter 1. Red Hat Cluster Suite Overview
Assume dead after (seconds)
If the primary LVS node does not respond after this number of seconds, then the backup LVS
router node will initiate failover.
Heartbeat runs on port
Sets the port at which the heartbeat communicates with the primary LVS node. The default is set
to 539 if this field is left blank.

1.10.4. VIRTUAL SERVERS

The VIRTUAL SERVERS panel displays information for each currently defined virtual server. Each
table entry shows the status of the virtual server, the server name, the virtual IP assigned to the
server, the netmask of the virtual IP, the port number to which the service communicates, the protocol
used, and the virtual device interface.
Figure 1.34. The VIRTUAL SERVERS Panel
Each server displayed in the VIRTUAL SERVERS panel can be configured on subsequent screens or
subsections.
To add a service, click the ADD button. To remove a service, select it by clicking the radio button next
to the virtual server and click the DELETE button.
46