Red Hat DIRECTORY SERVER 7.1 Installation Manual page 68

62
user id admin (151:Unknown error.)
Fatal Slapd Did not add Directory Server information to
Configuration Server.
ERROR.
Failure installing Red Hat Directory Server.
Do you want to
continue [y/n]?
This error occurs when a machine is not correctly configured to use DNS naming. The default
fully qualified host and domain name presented during installation is not correct. If you accept
the defaults, you receive the LDAP authentication error.
To install successfully, you need to provide a fully qualified domain name that consists of a local
host name along with its domain name. A host name is the logical name assigned to a computer.
For example,
mycomputer
(FQDN).
A fully qualified domain name should be sufficient to determine a unique Internet address for
any host on the Internet. The same naming scheme is also used for some hosts that are not on the
Internet but share the same namespace for electronic mail addressing.
"Failure (4322): Configuration initialization failed" error message on Linux
(from JRE 1.4), which the Administration Server uses to run servlets, requires that
libjvm.so
the
compat-libstdc++-6.2
prise Linux.
The package may or may not be installed depending on the options that were chosen when the
operating system was installed. If the package is not installed, you get an error similar to the one
in Example 7-2.
[18/Jun/2002:10:56:39] failure ( 4322): Configuration
initialization failed:
Error running init function load-modules: dlopen of
/export/dstest/bin/https/lib/libNSServletPlugin.so failed
(libstdc++-libc6.1-1.so.2: cannot open shared object file:
No such file or directory)
Example 7-2. Error — Missing
For more information on the Sun supplied package, check the JRE's release notes at
http://java.sun.com/j2se/1.4/install-linux.html.
Forgotten Directory manager DN and password
If you forget
Manager DN is by looking
serverRoot/slapd-serverID/config/dse.ldif
If you have forgotten the Directory Manager DN password, you can reset it by doing the follow-
ing:
1. Find the nsslapd-rootpw attribute in
crypted in any way (that is, it does not start with
exactly what is shown on the parameter.
2. If the attribute is encrypted, then delete the attribute value, and replace it with some clear-
text value. For example, if you change the nsslapd-rootpw attribute so that it is:
nsslapd-rootpw: my_password
is a host name and
package be installed when running the server on Red Hat Enter-
libstdc++
the manager DN,
for the
is a fully qualified domain name
example.com
Package
you can find out
nsslapd-rootdn attribute
.
. If the attribute value is not en-
slapd.conf
or
{SHA} {CRYPT}
Chapter 7. Troubleshooting
what the Directory
in the
), then the password is
file