Hp-Ux 11I Operating System - Red Hat DIRECTORY SERVER 7.1 Installation Manual

Chapter 2. Computer System Requirements
Lastly, edit the file
•
session required /lib/security/$ISA/pam_limits.so
You must log out and then log back in for changes in the
2.3.2.5. Installing Third-Party Utilities
You need the gunzip utility to unpack the Directory Server software. The GNU gzip and gunzip pro-
grams are described in more detail at http://www.gnu.org/software/gzip/gzip.html and can be obtained
from many software distribution sites.
You may need Adobe Acrobat Reader to read the documentation. If you do not have it installed, you
can download it from http://www.adobe.com/products/acrobat/readstep2.html.

2.3.3. HP-UX 11i Operating System

This section contains the following information:
Section 2.3.3.1 Verifying Disk Space Requirements
•
Section 2.3.3.2 Verifying Required System Modules
•
Section 2.3.3.3 Installing Patches
•
Section 2.3.3.4 Tuning the System
•
Section 2.3.3.5 Installing Third-Party Utilities.
•
2.3.3.1. Verifying Disk Space Requirements
Ensure that you have sufficient disk space before downloading the software.
Download drive: 120 MB
•
Installation drive: 2 GB
•
2.3.3.2. Verifying Required System Modules
Directory Server is not supported on HP-UX 10 or earlier versions. The minimum system module
required is HP-UX 11i. Directory Server may only be used on a 64-bit HP-UX 11i environment as a
64-bit process and may contain up to 8 GB of process memory.
For best results, Directory Server requires an HP 9000 architecture with a PA-RISC 2.0 CPU.
2.3.3.3. Installing Patches
Before you install Directory Server, ensure that the host system is updated with the latest patches
recommended by the operating-system vendor. Because the list of recommended patches changes
with time, you must always check the operating system vendor's site for a list of patches that you may
need to install. Listed below are two URLs to aid you in this effort:
http://welcome.hp.com/country/us/eng/support.htm
•
http://www.hp.com/products1/unix/java/
•
Here are some recommendations:
/etc/pam.d/system-auth
to include this line if it does not already exist:
limits.conf
file to take effect.
15